Docs Menu
Docs Home
/
MongoDB Manual
/ /

Mitigate Performance Issues with PSA Replica Set

On this page

  • Overview
  • Procedure

In a three-member replica set with a primary-secondary-arbiter (PSA) architecture or a sharded cluster with three-member PSA shards, a data-bearing node that is down or lagged can lead to performance issues.

If one data-bearing node goes down, the other node becomes the primary. Writes with w:1 continue to succeed in this state but writes with write concern "majority" cannot succeed and the commit point starts to lag. If your PSA replica set contains a lagged secondary and your replica set requires two nodes to majority commit a change, your commit point also lags.

With a lagged commit point, two things can affect your cluster performance:

  • The storage engine keeps all changes that happen after the commit point on disk to retain a durable history. The extra I/O from these writes tends to increase over time. This can greatly impact write performance and increase cache pressure.

  • MongoDB allows the oplog to grow past its configured size limit to avoid deleting the majority commit point.

To reduce the cache pressure and increased write traffic, set votes: 0 and priority: 0 for the node that is unavailable or lagging. For write operations issued with "majority", only voting members are considered to determine the number of nodes needed to perform a majority commit. Setting the configuration of the node to votes: 0 reduces the number of nodes required to commit a write with write concern "majority" from two to one and allows these writes to succeed.

Once the secondary is caught up, you can use the rs.reconfigForPSASet() method to set votes back to 1.

Note

In earlier versions of MongoDB, enableMajorityReadConcern and --enableMajorityReadConcern were configurable allowing you to disable the default read concern "majority" which had a similar effect.

To reduce the cache pressure and increased write traffic for a deployment with a three-member primary-secondary-arbiter (PSA) architecture, set { votes: 0, priority: 0 } for the secondary that is unavailable or lagging:

cfg = rs.conf();
cfg["members"][<array_index>]["votes"] = 0;
cfg["members"][<array_index>]["priority"] = 0;
rs.reconfig(cfg);

If you want to change the configuration of the secondary later, use the rs.reconfigForPSASet() method.

Back

Modify PSA Replica Set Safely

On this page